HuddleCamHD Knowledge Base

 3X / 3X-G2 / 10X-720 / 10X Camera ID Configuration

1. Look for the DIP switches on the bottom of the camera in the "SW1" group of DIP switches. 
2. Carefully adjust the DIP switches according to "PIC 1" to set the necessary ID for your camera              
3. Example(s) - PIC 1 showcases the settings for Camera ID 1, and PIC 2 showcases the settings for Camera ID 2
4. Do this for each camera in the chain you wish to assign in the same fashion; Camera ID 3 would be with SW1 DIP Switch 3 UP and all others DOWN.
5. Power on all you cameras.

    12X Camera ID Configuration

1. You will need to see the video output of the 12X via USB or DVI to set the appropriate address for each camera.
2. Go to the OSD by pressing the "Menu" button on your remote and select "System Option".
3. Make sure the "Protocol" is set to "VISCA", and your "B.Rate" is set to "9600".
4. In the same menu, for the camera you have chosen to be Camera 1, set "ADDR" to be "001".
5. Repeat step 4, with the minor variations noted, for any other camera(s) in the chain; Camera 2 would have an "ADDR" of "002", Camera 3 would be "ADDR" "003", etc...
6. Power on all you cameras.

    3XW / 3XW-G2 / 20X / 20X-G2 / 30X / 30X-G2 Camera ID Configuration

1. These cameras can be set to control up to three (3) cameras via the DIP Switch settings (chart provided below).
2. Decide which camera(s) you want to be Cam1, Cam2 and Cam3 respectively.
3. Set the DIP Switches on the bottom of the camera as follows to set as Cam 1 (Cam ID1). Turn ON DIP Switch 5 making sure DIP Switch 4 is OFF.
4. Set the DIP Switches on the bottom of the camera as follows to set as Cam 2 (Cam ID2). Turn ON DIP Switch 4making sure your DIP Switch 5 is OFF.
5. Set the DIP Switches on the bottom of the camera as follows to set as Cam 3 (Cam ID3). Turn ON DIP Switch 4 and turning ON DIP Switch 5.
6. Power on all you cameras.